Netgear AirCard 790S Mobile Hotspot

Search Cable Adapters

Find other Device Pigtails

Because the Netgear AirCard 790S Mobile Hotspot device has an external antenna port you could use the high gain external antenna kits above to boost your signal. However, if your outdoor signal is very weak, or you require a very long cable run to get from the outdoor antenna to the device (long runs lead to large signal loss) consider using an RF bidirectional amplifier/ repeater suitable for the supported bands and cellular operator to boost your indoor coverage:

LTE Antenna Boosters/ RF Bidirectional Amplifiers/ Repeaters/ Relays

STEP 1: Determine what frequency bands your operator uses here, then click on the frequency band link to view the best ranked cellular antennas compatible with the frequency band that both your device and your cellular operator supports. Your Netgear AirCard 790S Mobile Hotspot operates on these frequency bands: LTE Band 12, LTE Band 8, LTE Band 3, LTE Band 1, LTE Band 38, LTE Band 13, LTE Band 17.

STEP 2: Determine the cable length you need from the outdoor antenna to the Netgear AirCard 790S Mobile Hotspot and configure your length here (select N-Male on both ends)

STEP 3: Determine if you need a lightning protection device. If you do, you will need a jumper cable.

STEP 4: Order the pigtail for your modem below:

STEP 5: If the pigtail's Connector 2 is FME-F you will need an N-Female/FME-F adapter to mate to the N-Male cable in step 2. Alternatively, select an N-Male/FME-M cable in step 2 above (more expensive and less re-usable) to avoid requiring this adapter.

Contact us if unsure about any of the steps above or for help configuring your coverage/speed improvement solution or visit our support website to learn more.

To use your Netgear AirCard 790S Mobile Hotspot in a vehicle, consider the LTE antennas below.

Vehicle LTE Antennas

See below for other LTE antennas or contact us if you cannot find what you are looking for

Other LTE Antennas

Because the Netgear AirCard 790S Mobile Hotspot is not listed as having an external antenna port, you would need to use a wireless network extender or repeater to increase the WiFi signal coverage

Wi-Fi Coverage Extension Solutions

See below for wireless site components to integrate Netgear AirCard 790S Mobile Hotspot to your wireless infrastructure

Outdoor Radio Enclosure

Low loss RF Cables

Other Wireless Site Accessories

See below for alternate and portable power solutions for Netgear AirCard 790S Mobile Hotspot

Portable Power Solutions

Indoor coverage solutions

Select Case Studies

Support Knowledge Base

Search AC790S articles

Discuss in the Forums

Search AC790S posts

Ask a Question

Reference Engr Drawings